The Set Remote Display Options screen lets you select the information that appears on the
Remote Displays.

From STORE PARAMETERS Screen:

Press You are now in the SET REMOTE DISPLAY OPTIONS screen.

NOTE: A Timer may have up to six Remote Displays (one standard plus up to five optional). The first five show two types of data: 1) the elapsed time for the event assigned to the Display, continuously updated during the event; and, 2) the average time for the event computed over the daypart, shift, day, week, month, or year to date (as selected by the user), after the car leaves the station. The average time is re-computed after each car leaves the event assigned to the Display, and is shown by flashing numerals once the event station is no longer occupied.

Press to move the cursor to the desired Remote(s).

NOTE: If you do not know the number associated with a particular Remote Display, remove and reconnect the five-pin connector atop the Display. Do not remove the connector by pulling on the gray cable; remove it only by pulling on its black base. The unit then goes through a power-up sequence and displays the address of the Remote (the first number displayed).

IMPORTANT! While Remote Displays that show the time of the same event can have either the same or different addresses, if you want two or more Remote Displays to show the time of different events, each display must be set to a different address. (If the Display’s address is 001, it will show the time that Remote #1 is programmed to show as indicated on the Remote Display screen. If a Remote’s address is 002, it will show the time that
Remote #2 is programmed to show, etc.)

Press to move the cursor immediately to the right of the individual Remote address number(s) (i.e., #1).

Press or to select the averaging period (HOURLY; DAYPRTS; SHIFTS; DAILY; WEEKLY; MONTHLY; ALT). The averaging period applies to all Remote Displays. If you select a blank value, no averages will be flashed between events.

OPTION: The optional sixth Remote Display serves as a Special Percentage Remote, which can be used as a monitor of service speed, as well as a performance incentive for crew members. It shows, in either red or green numerals, the percentage of cars that satisfy the A-grade target time for the event monitored by the Display. If the percentage of cars satisfying the A-grade target time is below a percentage selected by the user, the Display numerals will be red. If the percentage is equal to or higher than the selected percentage, the numerals will be green.

Press to move the cursor to the sixth (last) Remote position (note that the default setting is 80%).

Press to move the cursor immediately to the right of REMOTE.

Press to move the cursor to [%].

Press or to select the event to be monitored.

NOTE: Depending on the model of the Timer, time data is shown either in
minutes:seconds or in seconds only. Time data is displayed only during the
hours the store is open. When closed, only a colon (two vertical dots) is shown
on a minutes:seconds Display; a seconds only Display is blank.

IF IT IS NECESSARY TO CHANGE A REMOTE DISPLAY’S ADDRESS,
USE THE FOLLOWING STEPS:
 

Once the Remote Display is addressed correctly, reassemble and remount it.

NOTE: To complete the procedure, Remote Display Options will need to be programmed to the correct settings. This requires a valid access code for entry.

Press . You are now in the SET REMOTE DISPLAY OPTIONS screen.