Setting Night Manager with 1000 Series Timer

Setting Night Manager allows management to review information about store operations during any period of time that is programmed. Typically, the Night Manager period coincides with the manager's off hours while the store is open. This allows management to review the drive-thru operation specifically for the selected time period. The Night Manager period of time must be set to operating hours (it cannot start before opening time or extend beyond closing time).

Note: If no keys are pressed in a short period of time, the timer times out and automatically returns to the Activity screen. If this occurs, any unsaved data will be lost.
   

1. Press to open Menu screen.
2. Press to move cursor to SET PARAMETERS.
3. Press and enter the 4-Digit Access Code. You are now in the Set Parameters screen.
4. Press until the cursor moves to NIGHT MANAGER.
5. Press The Set Night Manager screen appears and the cursor is on START.
6. Press

The cursor moves between START: and the selected time.

7. Press

or

to change START time up or down. Time changes in 15-minute increments.

Note: You cannot set the start time to before the store opening time.
8. Press

to move the cursor to STOP time.

9. Press

or

Press or to change STOP time up or down. Time changes in 15-minute increments.

Note: You cannot set the stop time past the store closing time.
10. Press The cursor moves to PRINT EACH CAR.

Note: Setting PEC to ON causes the printer to print a report for each and every car that goes through the drive-thru lane.
11. Press Press to change PRINT EACH CAR from OFF to ON or from ON to OFF. If PRINT EACH CAR (PEC) is ON, the Timer will PEC during the night manager period even though the feature may be set to OFF on the Printer Options screen.
12. Press twice to return to Activity screen.

back
Home | About | Drive-Thru Timers | Quick Service Timers | PC Software | Support | Service Providers | Contact